Cisco 3825 - Manual (Page 159)

A-27
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
gsm-abis congestion onset
gsm-abis congestion onset
Sets the congestion onset detection level at which the remote router will start suppressing all timeslots
that are not defined as critical in an effort to alleviate the congestion.
The onset detection level is defined as x milliseconds of continuous congestion detected. To set the congestion
onset, use the gsm-abis congestion onset Interface configuration command.
gsm-abis congestion onset [ms]
Syntax Description
Defaults There are no default settings or behaviors.
Command Modes Interface configuration
Command History
Examples The following example shows how to set the onset detection level at 50 ms:
Router(config)# interface Serial10/1/0:0
Router(config-if)# no ip address
Router(config-if)# encapsulation gsm-abis
Router(config-if)# load-interval 30
Router(config-if)# gsm-abis local 10.10.10.2 6661
Router(config-if)# gsm-abis remote 10.10.10.1 5553
Router(config-if)# gsm-abis congestion enable
Router(config-if)# gsm-abis congestion onset 100
Router(config-if)# no keepalive
Related Commands
ms Sets the number of milliseconds for the onset detection level.
Release Modification
12.4(2)MR This command was introduced.
Command Description
gsm-abis congestion abate Sets the congestion abatement detection level at which the remote
router will stop suppressing timeslots because congestion has been
alleviated.
gsm-abis congestion critical Defines the critical timeslots that are exempt from suppression
during congestion onset.
gsm-abis congestion enable Sets the congestion detection algorithm to monitor the transmit
jitter buffer and to send congestion indicator signals to the remote
when congestion is detected.
gsm-abis jitter Sets the amount of transmit jitter delay for the GSM-Abis interface.