Cisco 3825 - Manual (Page 184)

A-52
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
ipran-mib snmp-access
ipran-mib snmp-access
Use the ipran-mib snmp-access command in the global configuration mode to define the type of
connectivity between the device and the network management system. It is used to limit the amount of
traffic when in band polling.
ipran-mib snmp-access access
Syntax Description
Defaults inBand.
Command Modes Interface configuration
Command History
Examples
Router# config t
Router(config)# ipran-mib snmp-access inBand
Router(config)# ipran-mib snmp-access outOfBand
Router(config)# ipran-mib snmp-access undefined
Router(config)# no ipran-mib snmp-access
Router(config)# exit
Related Commands
ipran-mib snmp-access ? • inBand In Band SNMP connectivity.
• outOfBand Out of Band SNMP.
• undefined Undefined connectivity.
Release Modification
12.4(2)MR1 This command was introduced.
12.4(9)MR Support for utilization notification was removed. This command is supported to
maintain compatibility.
Command Description
ipran-mib location Defines the location of the device. It is also used to assist the network
management system in properly displaying the topology of the
system.