Cisco 3825 - Manual (Page 130)

4-72
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Chapter 4 Configuring the Cisco 3825 Mobile Wireless Edge Router in a RAN-O Solution with the Command-Line
Monitoring and Managing the Cisco 3825 Router
show interface type slot/port Displays the configuration and status of the
specified interface.
show interfaces fastethernet slot/port Displays the status of the FE interface.
show interfaces gigabitethernet slot/port Displays the status and configuration settings of
the GE interface.
show ip rtp header-compression Displays RTP header compression statistics.
show l2tp session Displays session information about active Layer 2
sessions.
show l2tp tunnel Displays information about active Layer 2
tunnels.
show mpls l2transport vc Displays information about Any Transport over
MPLS (AToM) virtual circuits (VCs) that have
been enabled to route Layer 2 packets on a router.
show network-clocks Displays the network clocking configuration.
show ppp multilink Displays MLP and multilink bundle information.
show ppp multilink interface number Displays multilink information for the specified
interface.
show protocols Displays the protocols configured for the router
and the individual interfaces.
show redundancy Displays current redundant setting and recent
changes in state.
show standby Displays HSRP configuration information.
show umts traffic Displays traffic rates, in bits per second, at 1
second, 5 seconds, 1 minute, 5 minutes, and 1 hour
intervals for UMTS data transmitted and received
over the backhaul.
show umts congestion atm Displays the UMTS Congestion state.
show umts-iub efficiency Displays the history of the UMTS Iub interface
efficiency averages for
compression/decompression at 1-second,
5-second, 1-minute, 5-minute, and 1-hour
intervals.
show umts-iub errors Displays error statistics UMTS-Iub interface.
show umts-iub packets Displays packet statistics of the UMTS-Iub
interface.
show umts-iub peering Displays peering status, statistics, and history of
the UMTS Iub interface.
show umts-iub pvc Displays the pvc mapping of the UMTS Iub
interface
show xconnect all Displays xconnect information.
Command Purpose