Cisco 3825 - Manual (Page 262)

A-130
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
umts-iub set peering dscp
umts-iub set peering dscp
To overwrite the interface default value defined in the umts-iub set dscp value and is used to tag the
peering backhaul packet, use the umts-iub set peering dscp Interface configuration command.
umts-iub set peering dscp value
Note Use this command when configuring UMTS shorthaul interfaces.
Syntax Description
Defaults There are no default settings or behaviors.
Command Modes Interface configuration
Command History
Examples The following example shows how to configure the parameters:
Router(config)# interface ATM0/2/0
Router(config-if) atm umts-iub
Router(config-if) umts-iub set dscp value
Related Commands
value A number from 0 to 63 that sets the UMTS-Iub DSCP value.
Release Modification
12.4(4)MR This command was introduced.
Command Description
umts-iub set dscp
(Interface Configuration mode)
This command sets the description value used as the interface
default description value to tag the backhaul packet including the
peering and data generated from the shorthaul.
umts-iub set dscp
(ATM-VC Configuration mode)
This command overwrites the interface default value defined in the
umts-iub set dscp value for UMTS shorthaul interfaces and is used
to tag the backhaul packet generated from traffic from a PVC