Specify the location of the interface – Cisco 3825 User Manual
Page 106
4-48
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Chapter 4 Configuring the Cisco 3825 Mobile Wireless Edge Router in a RAN-O Solution with the Command-Line
Configuration Sequence
For example, the following command specifies the class as the llq-class.
Router(config-pmap)# class llq-class
When you enter the class command, you are in the class submode of the policy-map configuration mode.
Step 3
Allocate a percentage of bandwidth to be used for the prority queue.
Router(config-pmap-c)# priority percent
number
For example, the following command specifies a priority percent number of 99.
Router(config-pmap-c)# priority percent 99
Step 4
Associate the llq-policy with a default class map. The default class is used for non-priority traffic.
Router(config-pmap-c)# class
class-default
Step 5
Allocate the remaining bandwidth to the default class.
Router(config-pmap-c)# bandwitdh remaining percent
number
For example, the following command specifies the remaining bandwidth as 1 percent.
Router(config-pmap-c)# bandwidth remaining percent 1
Step 6
Limit the queue depth of the default queue.
Router(config-pmap-c)# queue-limit
number
For example, the following command limits the queue depth to 45.
Router(config-pmap-c)# queue-limit 45
Note
The queue limit on the default class should be less than the hold-queue specified on the multilink
interface.
Step 7
Exit the class map and policy map configuration modes.
Router(config-pmap-c)# exit
Router(config-pmap)# exit
For more information about these commands, see the Cisco IOS Quality of Service Solutions Command
Reference for your Cisco IOS Release.
Specify the Location of the Interface
Step 1
Enter interface configuration mode and specify the location of the interface.
Router(config)# interface atm
slot/subslot/port
For example, the following command specifies the location of the interface as ATM0/0.
Router(config# interface atm0/0/0
Step 2
Disable the IP address configuration for the physical layer interface.
Router(config-if)# no ip address