Cisco 3825 - Manual (Page 123)

4-65
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Chapter 4 Configuring the Cisco 3825 Mobile Wireless Edge Router in a RAN-O Solution with the Command-Line
Saving Configuration Changes
disable-eadi
!
!
control-plane
!
line con 0
logging synchronous
line aux 0
line vty 04
login
password !--- Set VTY password
!
ntp server W.X.Y.Z !--- Set W.X.Y.Z to the NTP server on the network. This is important so
!that all the MWTM reports sync with the correct time. MWTM should sync to the same NTP
!server.
BSC/RNC Configuration
!
version 12.4
service timestamps debug datetime msec localtime
service timestamps log datetime msec localtime
no service password-encryption
!
hostname hostname !--- Enter <hostname> here
!
boot-start-marker
boot system flash slot0: !--- Image Name
boot-end-marker
!
card type e1 0 0
card type e1 0 1
card type e1 0 2
logging buffered 1000000 debugging
enable password !--- Set the ENABLE password here
!
no aaa new-model
!
resource manager
!
clock timezone EST -5 !--- Example of setting time zone
!
redundancy
mode y-cable
standalone
!
network-clock-participate wic 0
network-clock-participate wic 1
network-clock-participate wic 2
network-clock-participate aim 1
network-clock-select 1 E1 0/0/0
network-clock-select 2 E1 0/0/1
network-clock-select 3 E1 0/1/1
network-clock-select 4 E1 0/2/0
mmi polling-interval 60
no mmi auto-configure
no mmi pvc
mmi snmp-timeout 180
ip subnet-zero
no ip dhcp use vrf connected
!
!