To change the hysteresis, Toshiba – Toshiba LF434 User Manual
Page 65
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TOSHIBA
6 F 8 A 0 7 7 0
To change the hysteresis:
The hysteresis is set ai /!% (default) when shipped from the factory.
The following example shows how' to change the hysteresis from
1 > %
to 5%.
Key operation
Display example
Dciscription
^ET
□
C i :
RANGE HY$T
03. 0
%
Press [SETj first to siart the items selection sequence
iind sd eel
C6i RANGE HYST fro m a mo ng the
configuration items using [ ► J and [
a
j keys. Then
press [SET] again to display the current hysteresis
( 3 . 0 %
in this example).
►
CG: RANGE HYST
03, 0
%
Pressing [ ► ]* the cursor appears.
►
□
C6: RANGE HYST
oa. 0
%
Press [ ► ] to move the cursor to the desired digit to
change.
▲
□
CG: RANGE HYST
05. 0
%
Change the value to “5” by pressing [
^ ]
twice.
(if necessary, move the cursor to another digit and
change the value).(Note)
SET
CG: RANGE HYST
05. D
%
Pressing fSET], the cursor disappears and the
changed display flickers. Press [SE'll again to store
the changed iwsteresis.
SET
□
CG: RANGE HYST
Pressing [SET], the system returns to the item selec
tion sequence.
Note: if you try to set the hysteresis above 25.0 %,an error message H. OVER SPEC.'
appears. Try again to set the value within the specified range.
-
64
-