Toshiba LF434 - Manual (Page 69)

TOSHIBA
6 F 8 A 0 7 7 a
Tu change the low cutoff value:
The following cxpmpic show-s how lo dinnge the low cutolT vplue from 1,0 % to 3.0 % .
Key operation Display example Description
S E T D2: LOW CUT
OEO %
Press [SET] first to start the items s elect ion sequence
and select D2: LOW CUT from among the
configuration items using [ ► ] and f
a ] keys. Press
SET] again to display the current low cutoff value
(1.0% in this example).
k
□
D2: LOW CUT
OED %
Pressing [ ► ]»the cursor appears. Then press [ ► ] tCf
move ihe cursor to the digit to be changed.
▲
□ D2: LOW CUT
03.0 X
Change the value to "‘3” by pressing [ a ] twice. (Note)
(If necessary, move the cursor to another digit by
pressing [ ► ] and change the value.)
SET
□
D 2 : LOW CUT
03.0 SI
Pressing [SET], the cursor disappears and the changed
display flickers. Press [SET] again to store the value.
SET
□
D2: LOW CUT Pressing [SET], the system returns to the items
selection sequence.
Note: If you try to set the low cutoff value above 10 of the span, an error mcii^sagc
i R OVER SPEC appears. Set tlie value within the specified range,
-
68
-