Toshiba LF434 - Manual (Page 96)

TOSHIBA
6 F 8 A 0 7 7 0
*In case of foi^etting password (reading out password)
Proceed as follows lo only rciidout password in case of iorgeuing password. In the other
c^se, do not do it,
<Notice>
The incihod of PASSWORD MANAGl£MENT' including its lifting or reading out requires
to be controlled bv system’s own risk.
■ Readout the password:
The following example show's how- to readout the password .
Key operation Display example Description
Befor turning on pow'cr, open the housing cover for
LCrD display, atid short-circuit between Tl’-RST and
TT-G that is back of the operation panel w'ith the
clip-type cablc.(refer to Figure 8,1)
After that, turning on power, LCD back-light bright,
in the operation panel
10. 00 iti/s
100. 0 %
Open the dip-type cable,
LCD displays ''SIGNAL CHECK”, and after that
displays measured dala.(measufemein mode)
SET
□
PASSWORD INPUT
000
Pressing [SET), password input mode and the cursor
appears.
□ □
PASSWORD INPUT
lOD
m
123
Chiinge the value by pressing [ A j.and [ ► ),
SET
□
PASSWORD INPUT
123
Prcfssing [SET], the cursor disappears and the changed
display flickers. Press [SET] again to input the value.
SEP
□
Al: EX. CURR. Whether input password agrees or dose not agree , the
items selection sequence, "A1; EX. CURR” appears,
^ ►
□ □
A4: PASSWORD Select A4: PASSWORD from among the configuration
items using [ ► ] and [
a ] keys ,
SET
□
A4: PASSWORD
123
Press [SET] again to display the current
passw'orri(123).
“
9 5
-