Canon MARKLL WUX10 - Manual (Page 20)

Projector WUX10 MarkII User Commands
- 16 -
Revision History / Date Changes Revised by Approved by
ASPECT
Screen settings
Format
ASPECT=<Screen setting parameters:ID>
GET□ASPECT / ?△ASPECT
<Screen setting parameters:ID>
AUTO Auto
4:3 4:3
16:9 16:9
FULL Full
screen
ZOOM Zoom
TRUE Real
Environment
Power Input
OFF ON PM Parameter D-RGB A-RGB1 A-RGB2 COMP VIDEO HDMI None
X O X AUTO ○ ○ ○ ○ × ○ *4
4:3 ○ ○ ○ ○ ○ ○ *4
16:9 ○ ○ ○ ○ ○ ○ *4
FULL *5 *5 *5 Ч Ч Ч *4
ZOOM Ч Ч Ч *1 *2 *1 *4
TRUE ○ ○ ○ *3 × *3 *4
*1 Valid when screen aspect (16:9 or 16:9 DIS) and SD signals
*2 Settable when screen aspect (16:9 or 16:9 DIS)
*3 Progressive allowable (however, 1080p is non-allowable)
*4 Allowable/Non-Allowable differs according to selected input signal
*5 Settable when screen aspect (16:10)
Response
"i:OK" is returned if the parameter was set properly.
For '
GET ASPECT
' or '
?ASPECT
', current screen display mode is returned as
'g:ASPECT=<Screen setting parameters:ID>'
For details on other responses, refer to the "Error List".
Description
(1) This sets the screen sizes.
(2) This command functions in the same way as when "Display settings" - "Aspect" are selected on
the menu.
(3) If the command cannot be supported, 'INVALID_SOURCE' is returned as an error response.
(4) If the necessary signals are not input, 'NO_SIGNAL' is returned.
(5) The final screen settings are retained even when the power is turned off. However, the screen
settings may be different if the input terminal or input signal is changed.
(6) The GET command can be used to retrieve the current screen display mode. (" GET ASPECT ")