Canon MARKLL WUX10 - Manual (Page 56)

Projector WUX10 MarkII User Commands
- 52 -
Revision History / Date Changes Revised by Approved by
MUTE
Mute control
Format
MUTE=<Mute control parameter: ID>
GET□MUTE / ?△MUTE
<Mute control parameter: ID>
ON This turns off the audio/beep sound.
OFF This returns the audio/beep sound to its original setting.
Environment
Power Input
OFF ON PM D-RGB A-RGB1 A-RGB2 COMP VIDEO HDMI None
X O X -
Response
"i:OK" is returned if the parameter was set properly.
For '
GET MUTE ' or ' ?MUTE ', current mute setting is returned as
'g:MUTE=<Mute control parameter: ID>'
For details on other responses, refer to the "Error List".
Description
(1) This command is used to set the sound output muting to ON or OFF.
(2) Mute control enables simultaneous control of the audio and beep sound.
(3) This command is identical to pressing the MUTE button on the remote control.
(4) The mute setting is always "OFF" when the power has just been turned on.
(5) The volume can be set even when it is on "MUTE".
(6) The current muting status can be acquired using the applicable GET command. ("
GET MUTE ")
Example
Setting
> MUTE=ON
This mutes the volume.
< i:OK
Reference
> GET MUTE or ?MUTE
This retrieves the volume state.
< g:MUTE=ON
* Commands are indicated by ">", and responses are indicated by "<".