Canon MARKLL WUX10 - Manual (Page 44)

Projector WUX10 MarkII User Commands
- 40 -
Revision History / Date Changes Revised by Approved by
IMAGE
Image mode setting
Format
IMAGE=<Image mode setting parameter:ID>
GET□IMAGE / ?△IMAGE
<Image mode setting parameter:ID>
STANDARD Standard
PRESENTATION Presentation
SRGB sRGB
MOVIE Movie
PHOTO
Environmental light compatible sRGB
DCM_SIM DICOM monochrome *
* "e:000A INVALID_PARAMETER" is returned if the model is not DICOM compatible
Environment
Power Input
OFF ON PM D-RGB A-RGB1 A-RGB2 COMP VIDEO HDMI None
X O X -
Response
"i:OK" is returned if the parameter was set properly.
For '
GET IMAGE
' or '
?IMAGE
', current image mode is returned as
'g:IMAGE=<Image mode setting parameter:ID>'
For details on other responses, refer to the "Error List".
Description
(1) This sets the image quality.
(2) This command functions in the same way as when "Image adjustment" - "Image mode setting"
are selected on the menu.
(3) The final settings for the image mode are retained even when the power is turned off.
(4) Changing the setting may modify the following setting values.
Setting Commands related to the settings
Brightness BRI
Contrast CONT
Sharpness SHARP
Gamma adjustment GAMMA
Dynamic gamma DGAMMA
Progressive PROG
Saturation/Hue SAT/ HUE
Memory color adjustment MEMCADJ
RGB gain/offset adjustment RGBGAIN/RGBOFFSET
Lamp mode LAMP
6-axis adjustment 6AXADJ
6-axis color correction 6AXR～Y
(5) The current image quality can be acquired using the applicable GET command. ("
GET IMAGE ")