Canon MARKLL WUX10 - Manual (Page 85)

Projector WUX10 MarkII User Commands
- 81 -
Revision History / Date Changes Revised by Approved by
7. Error List
Item Code TYPE Error character strings Error Remedy
1 0001 e BAD_SEQUENCE Communication sequence error
Wait until a response is received
before sending the next command.
2 0002 e INVALID_COMMAND Invalid (undefined) command. Send a valid command.
3 0004 e INVALID_FORMAT Invalid command format.
Send the command in the valid
format.
4 0005 e NOT_POWER_SUPPLIED The projector's power is off.
Turn on the power using the
POWER ON command.
5 - i BUSY (POWER)
The projector is switching power
modes. Wait until the power mode is ON,
OFF or PMM.
6 000A e INVALID_PARAMETER
The parameter (type) is invalid
(undefined). Includes cases when
the number of parameters is
incorrect.
Use the correct parameters.
7 000B e JOB_TIMEOUT
Internal processing in the projector
has timed out.
Resend the command.
i BUSY (FOCUS) The focus lens is being driven.
Wait until the projector has finished
driving the focus lens.
i BUSY (ZOOM) The zoom lens is being driven.
Wait until the projector has finished
driving the zoom lens.
i BUSY (LOGO_CAPTURE)
User image registration is in
progress. Wait until user image registration is
complete.
i BUSY (IMAGE)
Image mode switching is in
progress. Wait until the projector has switched
the image mode.
i BUSY (NOW_SETTING)
Signal setting (detection) in
progress. Wait until the processing is
completed.
9 -
i BUSY
Internal processing in the projector
is in progress. Wait until the current processing is
complete.
1006 e NOW_BLANK
Cannot execute command since
blanking operation is in progress. Resend the command after
canceling the blanking operation.
1009 e NOW_FREEZE
Cannot execute command since
freeze operation is in progress. Resend the command after
canceling the freeze operation.
100A e NOW_D.ZOOM
Cannot execute command since
D. zooming is in progress. Resend the command after
canceling D. zooming.
10
100B e NOW_SPECIAL_MENU
Cannot execute command in
current menu mode. Resend the command after exiting
the current menu mode.