Canon MARKLL WUX10 - Manual (Page 23)

Projector WUX10 MarkII User Commands
- 19 -
Revision History / Date Changes Revised by Approved by
AUTOSETEXE
Auto setup
Format
AUTOSETEXE□<Auto set parameter:ID>
<Auto set parameter:ID>
FOCUS Auto focusing
VKS Auto keystone (vertical) execution
SCRN Automatic screen color correction execution
INPUT Automatic signal sensing execution
Environment
Power Input
OFF ON PM D-RGB A-RGB1 A-RGB2 COMP VIDEO HDMI None
X O X -
Response
“ i:OK” is returned when the automatic processing was completed successfully.
For details on other responses, refer to the "Error List".
Description
(1) This command is used to execute auto setup.
(2) One of the following responses is returned if auto setup cannot be executed due to projector
settings.
Type
Projector
settings FOCUS VKS SCRN INPUT
Error response
BLANK Ч ○ Ч ○ 'e:1006 NOW_BLANK'
FREEZE Ч Ч Ч Ч 'e:1009 NOW_FREEZE'
D.ZOOM Ч Ч Ч Ч 'e:100A NOW_D.ZOOM' ○： Executable
DIS* Ч Ч Ч ○ 'e:1008 INVALID_SCREEN_ASPECT' ×： Non-executable
* DIS:Digital Image Shift
(3) One of the following responses is returned if an error has been detected at any part of the auto
setup.
Type Response
FOCUS 'e:F002 SYSTEM (AF)'
VKS 'e:F004 SYSTEM (AK)'
SCRN 'e:F005 SYSTEM (ASC)'
(4) If the input signal cannot be detected using the automatic signal sensing,
' i:INPUT_NOT_FOUND ' is returned.
(5) When automatic screen color correction (SCRN) has been completed successfully, the screen
color correction (WB) is set to "ADJUST".
(6) There are no parameters to be executed together. Execute them separately.
Example
Setting
> AUTOSETEXE FOCUS Auto focusing is executed.
< i:OK
* Commands are indicated by ">", and responses are indicated by "<".