Canon MARKLL WUX10 - Manual (Page 28)

Projector WUX10 MarkII User Commands
- 24 -
Revision History / Date Changes Revised by Approved by
BVOL
BEEP sound setting
Format
BVOL=<Beep sound setting:Number>
GET□BVOL / ?△BVOL
<Beep sound setting:Number>
0 BEEP sound mute
1 BEEP sound output
Environment
Power Input
OFF ON PM D-RGB A-RGB1 A-RGB2 COMP VIDEO HDMI None
X O X -
Response
"i:OK" is returned if the parameter was set properly.
For '
GET BVOL ' or ' ?BVOL ', current BEEP sound setting is returned as
'
g:BVOL=<Beep sound setting:Number>
'
For details on other responses, refer to the "Error List".
Description
(1) This sets the BEEP sound output.
(2) This command functions in the same way as when "System setting" - "Electronic sound" are
selected on the menu.
(3) The beep sound can be set even while the sound is muted, but it will not sound even if (beep
sound output) has been set.
(4) The current beep sound output status can be acquired using the applicable GET command.
("
GET BVOL
")
Example
Setting
> BVOL=0 This mutes the BEEP sound.
< i:OK
Reference
> GET BVOL or ?BVOL This retrieves the BEEP sound output state.
< g:BVOL=1
* Commands are indicated by ">", and responses are indicated by "<".