Canon MARKLL WUX10 - Manual (Page 65)

Projector WUX10 MarkII User Commands
- 61 -
Revision History / Date Changes Revised by Approved by
RCCH
Remote control channel setting
Format
RCCH=<Remote control setting parameters:ID>
GET□RCCH / ?△RCCH
<Remote control setting parameters:ID>
1 Remote control channel 1
2 Remote control channel 2
Environment
Power Input
OFF ON PM D-RGB A-RGB1 A-RGB2 COMP VIDEO HDMI None
X O X -
Response
"i:OK" is returned if the parameter was set properly.
For '
GET RCCH ' or ' ?RCCH ', current remote control channel setting is returned as
'g:RCCH=<Remote control setting parameters:ID>'
For details on other responses, refer to the "Error List".
Description
(1) This command is used to set the channel of the remote control used at the projector end to 1 or
2.
(2) This command functions in the same way as when "System setting" - "Other settings" -
"Remote control setting" are selected on the menu.
(3) The current remote control setting can be acquired using the applicable GET command. (" GET
RCCH ")
Example
Setting
> RCCH=1
This sets the remote control channel to ch1.
< i:OK
Reference
> GET RCCH or ?RCCH
This retrieves the remote control setting state.
< g:RCCH=2
* Commands are indicated by ">", and responses are indicated by "<".