Canon MARKLL WUX10 - Manual (Page 32)

Projector WUX10 MarkII User Commands
- 28 -
Revision History / Date Changes Revised by Approved by
DOTS
Total number of dots adjustment
Format
DOTS=<Number of dots:Number>
GET□DOTS / ?△DOTS
Environment
Power Input
OFF ON PM D-RGB A-RGB1 A-RGB2 COMP VIDEO HDMI None
X O X X O O X X X X
Response
"i:OK" is returned if the parameter was set properly.
For '
GET DOTS ' or ' ?DOTS ', current total number of dots is returned as
'
g:DOTS=<Number of dots:Number>
'
For details on other responses, refer to the "Error List".
Description
(1) This designates the total number of dots for one horizontal period.
(2) This command functions in the same way as when "Display setting" - "Input signal settings" -
"Total number of dots" are selected on the menu.
(3) If the input is neither "A-RGB1" nor "A-RGB2", 'e:200X INVALID_SOURCE(***)' is returned
as an error response.
(4) If signals are not input, 'e:2010 NO_SIGNAL' is returned.
(5) Adjustment range is limited. If number is invalid, "e:0801 INVALID_VALUE" is returned.
(6) The GET command can be used to obtain the current total number of dots. ("
GET DOTS
")
Example
Setting
> DOTS=1650 The total number of dots is 1650.
< i:OK
Reference
> GET DOTS or ?DOTS This retrieves the total number of dots.
< g:DOTS=1200
* Commands are indicated by ">", and responses are indicated by "<".