Changing needle plates, Attaching snap-in feed cover, Changing the needle – SINGER 3150 User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Changing Needle Plates
NOTE: Remove bobbin if it contains thread in
order to prevent thread being caught when
plate is replaced.
•
Raise needle to highest position by turming
the hand wheel toward you.
•
Raise presser foot.
•
Open slide plate. Place thumb under right
side of needle plate, lift it up and withdraw
it to right.
•
Replace needle plate under clamping pin A,
push it firmly to the left and press down
until it snaps into place
•
Close slide plate.
Attaching Snap-In Feed
Cover
•
Raise needle to highest position by turning
hand wheel toward you.
•
Raise presser foot, open slide plate and
insert general purpose needle plate.
•
Slide snap-in feed cover away from you over
needle plate until points B and C are
positioned directly over holes in needle
plate as illustrated. Snap in point B. Then
push point C in toward point B until it
snaps into place. Close slide plate.
•
To remove, open slide plate, then simply lift
up front edge of feed cover and remove.
Close slide plate.
Changing the Needle
•
Raise needle to its highest position by
turning the hand wheel toward you. Loosen
the needle-clamp screw D and remove the
needle.
•
Insert new needle with the flat side of the
needle to the back, up into clamp E as far as
it will go.
•
Tighten needle-clamp screw.
15
J