Threading the machine – SINGER 3150 User Manual
Page 29
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Threading the Machine
•
Place spool of thread on spool pin. If spool
being used has a thread retaining slit A, it
should be placed to the right, as illustrated.
•
Raise the presser foot, to release thread
tension.
•
Raise the take-up lever to highest position
by turning hand wheel toward you,
•
Snap thread into thread guide post 1.
•
Holding thread ends In each hand, snap
thread into upper thread guide 2.
•
With right hand on thread spool, thread the
needle thread tension 3. Slide thread over
metal plate between tension discs with left
hand.
Lead
thread
under
tension
and
tension wire. Thread tension wire by firmly
pulling thread up and over to the right.
•
Thread take-up lever 4, as illustrated.
•
Draw thread through points 5 and 6, guiding
thread from rear of each guide to the right.
•
Pass thread through guide 7. Thread the
needle 8 from front to back, drawing 10 cm
(4 inches) of thread through the needle eye.
27