Changing the light buib, Replacing the slide plate – SINGER 3150 User Manual
Page 87
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Changing the Light Buib
CAUTION:
Disconnect power-line plug fronn
electrical outlet before removing old bulb.
Remove face plate, as instructed on page 79.
Removing Bulb^ Press bulb into socket and at
the same time turn bulb in direction shown to
unlock bulb pin. (Do not attempt to unscrew
the light bulb).
Note:
This machine is designed to use a 15
watt maximum light bulb.
Replacing Bulb:
Press new buib into socket,
with bulb pin entering slot of socket, and turn
it in direction shown to lock bulb in position.
Replace face plate.
Replacing the Slide Plate
You will not have any occasion to remove the
slide plate. However, if it should accidentally
become disengaged from the machine, it Is
easily replaced.
•
Raise the presser foot and make sure needle
is in its highest position.
•
Place slide plate in slide way with the front
edge close to, but not covering, the retaining
spring (as shown).
•
With a Sir«II screwdriver, lift each end of the
spring into each of the side grooves on the
underside of the plate.
•
Draw the plate gently toward you and fully
engage the spring.
•
Close slide plate.
85