Pitney Bowes DI380 OfficeRight Systems - Manual (Page 18)

2 • Operation
2-2 SV61789 Rev. A
Select a Job
When the machine is turned ON,
the display shows the last job run
and Tral Pece Requred.
Press the
Job button until the
job you want displays, or press
Default if you want to run the
machine with your standard job
settings.
Note: Only a Pitney Bowes Service Representative can modify the
default job.
If you have material loaded, press
Trial Piece. The machine will set
itself and run a test piece for you
to check.
If you don’t have material loaded,
do this now, then return to this
section. You’ll find instructions for loading the machine on pages 2-4
to 2-9.
Note:
You may have selected a manual feed job where sheet feeder 1 is
set for manual feed of collated sets. If this is the case, DO NOT load
the sheet feeder. Instead, you’ll feed collated sets one at a time by
hand as required by the machine.
Before you run a manual feed
job, pull back the lever as shown
at the right. This opens the feed
mechanism for manual feed op-
eration.
Remember to return this lever to
its normal position when you use
the feeder for automatic opera-
tion.