Pitney Bowes DI380 OfficeRight Systems - Manual (Page 39)

Operation • 2
2-23 SV61789 Rev. A
Testing the Job
Load material and press Trial Piece so that you can check if the set-
up is correct.
You can make minor changes to the job settings at this stage if the
trial piece needs fine tuning. Press Setup, then use the Prev (◄),
Next (►) and Change (+/-) buttons as required to modify job set-
tings. The chart below may help you fine tune your fold settings.
FOLD TYPE ADDRESS TOO LOW ADDRESS TOO HIGH
C — Letter Fold Decrease Fold A Increase Fold A and
increase Fold B by
the same amount
Z — Accordion Increase Fold A Decrease Fold A a
Fold increase Fold B by
the same amount
Single Fold Increase Fold A Decrease Fold A
Double Fold Decrease Fold A Increase Fold A
We suggest you change the fold by 0.20 inches (5mm) each time
and run a new trial piece run to test the settings.
When you’ve made the necessary changes, press
Setup again to re-
turn to run mode. Your inserter system will save the job with the new
settings.