Pitney Bowes DI380 OfficeRight Systems - Manual (Page 40)

2 • Operation
2-24 SV61789 Rev. A
Changing an Existing Job
To change an existing job…
1. Enter the setup mode as described on page 2-11.
2. Use the
Change (+/-) buttons to display the job you wish to edit.
3. Use the Prev (◄) and Next (►) buttons to display the setting(s)
you want to change.
4. Use the Change (+/-) buttons to change the options and or di-
mensions you want.
5. Press Setup to leave setup mode and save the changes.
Deleting a Job
To erase an existing job from memory, follow the steps below:
1. Enter the setup mode as described on page 2-11.
2. Use the
Change (+/-) buttons to display the job you want to de-
lete.
3. Press the Delete button. The display reads “Press again to con-
firm”. Press Delete again. The display will briefly read “Deleting
Job” as the job is erased.
4. Press Setup to leave setup mode.