Pitney Bowes DI380 OfficeRight Systems - Manual (Page 28)

2 • Operation
2-12 SV61789 Rev. A
Choosing the New Job Number
The machine will ask for the job
number you wish the new set-
tings to be stored under. Use the
Change (+/-) buttons to display
the job number you want.
Notes:
• If you use an existing job number, the old settings will be over-
written by the new settings you are about to make.
• If you want to find a currently unused job number, press Change
( +/-) until you see a job where the display shows no symbols
alongside the feeders or in the fold setup area. This means the
job number is unused and available.
Press Next (►) to advance to the next setting…
OMR
On models equipped with OMR ONLY, you will now be asked to se-
lect the OMR mode. For a non-OMR job, use Change (+/-) to select
OMR off. If you wish to program an OMR job, see page 3-10.
Press
Next (►) to advance to the next setting…