Pitney Bowes DI380 OfficeRight Systems - Manual (Page 26)

2 • Operation
2-10 SV61789 Rev. A
Filling the Sealer
When the sealer unit needs refilling, the Add Sealing So-
lution symbol flashes in the display.
Add E-Z Seal ® Sealing Solution or water in the following
way:
Note: We recommend Pitney Bowes E-Z Seal to minimize growth
of algae and scale build-up.
Hinge open the sealer bottle cov-
er located at the rear right hand
side of the machine. Remove the
bottle.
Fill the bottle up to the level indi-
cated.
Place the sealer bottle in posi-
tion in the machine and close the cover.
Note: If the sealer unit was completely empty, allow time for the
fresh solution or water to soak through the sealer before you
resume operation. This helps assure a good seal.
Adjusting the Stacker
Adjust the drop stacker to suit the
material you’re running.
Lift the lever at the rear of the
stacker and adjust the stacker to
one of the preset positions. Low-
er the lever to lock the stacker
into position.
When not in use, you can raise
the stacker and latch it vertically against the exit area of the machine.