Comtech EF Data CDS-100 - Manual (Page 22)

CDS-100 Diversity Switch MN-CDS100
Introduction Revision 1
1–2
The CDS-100 is compatible for use with the Comtech EF Data modems listed in Table 1-1. This
table summarizes the requirements for supporting data switching hardware and software.
Table 1-1. CDS-100 Compatibility Summary
Modem 1:1 Data Switch Firmware/Hardware Requirement Note 3
CDM-625A Built into the CDM-625A Firmware Ver. 1.1.1 or higher
CDM-625 Built into the CDM-625 Firmware Ver. 1.1.1 or higher
CDM-850 Built into the CDM-850 Firmware Ver. 1.7.1.X or higher
CDM-840 Built into the CDM-840 Firmware Ver. 1.2.4 or higher
CDM-760 Built into the CDM-760 Firmware Ver. 1.1.1 or higher
CDM-750 Built into the CDM-750 Firmware Ver. 1.1.1 or higher
CDM-570AL Built into the CDM-570AL Firmware Ver. 1.1.1 or higher
CDM-570L Built into the CDM-570L Firmware Ver. 1.6.7 or higher
CDM-570L w/IP Module User-provided hub or Layer 2 switch Firmware Ver. 1.5.4.2 or higher
CDM-570A Built into the CDM-570A Firmware Ver. 1.1.1 or higher
CDM-570 Built into the CDM-570
• Firmware 1.6.7 or higher
• Hardware Revision 3
CDM-710G/L Built into the CDM-710G/L Firmware Ver. 5.1.1 or higher
CDM-710 Built into the CDM-710
• Firmware Ver. 2.4.1 or higher;
• Chassis Rev. A or higher
CDM-700 Built into the CDM-700
• Firmware Ver. 1.1.6 or higher;
• Chassis Rev. A or higher
Firmware updates are free and may be downloaded from the Comtech EF Data
web site (www.comtechefdata.com). If a modem does not meet the hardware
requirements, contact Comtech EF Data Product Support – hardware revision
upgrades must be performed at CEFD.