Electro-Chemical Devices (ECD) T80 - Manual (Page 13)

UNPACKING THE INSTRUMENT
Your Electro-Chemical Devices instrument has been carefully packaged to protect it from damage during
shipment and dry storage. Upon receipt please follow the procedure outlined below.
1. Before unpacking, inspect the condition of the shipping container to verify proper handling by the
carrier. If damage is noted, save the shipping container as proof of mishandling for the carrier.
2. Check the contents of the shipping container with the items and quantities shown on the packing list.
Immediately report any discrepancies to ECD.
3. Save the original packing material until you are satisfied with the contents. In the event the product(s)
must be returned to ECD, the packing material will allow you to properly ship it to ECD.
4. Familiarize yourself with the instrument before installation, and follow proper installation and wiring
procedures.
5.
Installation and wiring
Failure to follow the proper instructions may cause damage to this instrument and warranty invalidation.
Use only qualified personnel to install, operate and maintain the product.
The Model T80 transmitter should only be used with equipment that meets the relevant IEC, American or
Canadian standards. ECD accepts no responsibility for the misuse of this unit.
Basic Parts List
1. Model T80 Transmitter
2. Mounting Hardware
3. Instruction Manual
INSTRUCTION MANUAL REVISION
Revision Date Remarks
A 07/12 Initial release
B 03/13 Added Sensors and Conductivity Data
C 03/13 Updated Symbols
D 07/13 MODBUS Update
E 07/13 Turbidity, Conductivity, Cal Menu
F 05/14 Two Channels, MODBUS Update,
WARNING Electrical installation must be in accordance with the National Electrical Code
(ANSI/NFPA-70), Canadian Electrical Code and/or any other applicable national or local
codes.
12