Flowserve SPECTORcontrol - Manual (Page 47)

47
Controller Menu
– continued –
Continuous controller
1. Press button in the menu Continuous controller setup .
2. The menu Continuous controller is
password protected. Press button and
enter your password.
3. The name of the controller is highlighted in
yellow. Below that the current actual value,
the setpoint as well as the current control-
ler position are indicated.
4. To change the internal setpoint click in
the green input field.
5. The current value appears in the input
mask. Use the on-screen keyboard to
overwrite or modify the value.
6. When you switch to manual operation you can enter a manipulated variable in the
input field
Manual . For this purpose click in the green input field.
7. The current value appears in the input mask. Use the on-screen keyboard to over-
write or modify the value.
8. Use the button to activate either automatic operation, off or manual operation. The
adjusted mode of operation will be indicated by a larger icon next to the button.
9. Use the input fields P (proportional), I (integral) and D (differential) to enter the control
parameters of the PID controller.
10. The current value appears in the input mask. Use the on-screen keyboard to over-
write or modify the value.
11. Below the status indicator Enabled/Disabled and the adjusted controller the actual
value (X), the setpoint (W) and the manipulated variable (Yx) as well as the position
feedback (Yx) are graphically represented in the form of a bar chart.
Continuous Logo
Controller 1
Actual
Enabled
TEST 2
0.0 % 0.0
0.0 NC
0.0
0.0
0.0
0.0
Int. setpoint
Position
Manual:
Note
In this menu only an internal setpoint can be established.
If you change the switch setting from automatic operation to Off, the current
manipulated variable (Yw) of the controller will appear in the field Manual.
If the controller features an external setpoint element that is defective, the
internal setpoint will become active and can be adjusted.