Fronius Agilo 75.0 - Manual (Page 12)

10
Protective meas-
ures against ESD
Safety measures
in normal opera-
tion
Safety symbol
Disposal
Data protection
Copyright
Danger of damage to electrical components from electrical discharge. Suitable
measures should be taken to protect against ESD when replacing and install-
ing components.
Only operate the device if all safety devices are fully functional. If the safety
devices are not fully functional, there is a risk of
-
injury or death to the operator or a third party,
- damage to the device and other material assets belonging to the operator,
- inefficient operation of the device.
Any safety devices that are not functioning properly must be repaired by a suit-
ably qualified engineer before the device is switched on.
Never bypass or disable safety devices.
Devices with the CE mark satisfy the essential requirements of the low-voltage
and electromagnetic compatibility directives. Further details can be found in
the appendix or the section headed "Technical data" in your documentation.
To comply with the European Directive 2002/96/EC on Waste Electrical and
Electronic Equipment and its implementation as national law, electrical equip-
ment that has reached the end of its life must be collected separately and re-
turned to an approved recycling facility. Any device that you no longer require
must either be returned to your dealer or given to one of the approved collec-
tion and recycling facilities in your area. Ignoring this European Directive may
have potentially adverse affects on the environment and your health!
The user is responsible for the safekeeping of any changes made to the fac-
tory settings. The manufacturer accepts no liability for any deleted personal
settings.
Copyright of these operating instructions remains with the manufacturer.
The text and illustrations are all technically correct at the time of printing. We
reserve the right to make changes. The contents of the operating instructions
shall not provide the basis for any claims whatsoever on the part of the pur-
chaser. If you have any suggestions for improvement, or can point out any
mistakes that you have found in the instructions, we will be most grateful for
your comments.