Teac HS-P82 - Manual (Page 11)

TASCAM HS-P82
11
Right side panel
a LINE OUT connectors
Connect a monitor speaker system or other equipment
to these balanced XLR analog connectors (1: GND, 2:
HOT, 3: COLD) that output the internally-mixed stereo
signal.
s MIC/LINE selection switches
Set these switches according to the type of input signal.
MIC 0 : Use when inputting a microphone.
MIC –25 : Use when inputting a microphone. This
applies a 25 dB pad to the mic input.
LINE : Use for line level input.
d MIC/LINE IN connectors
These are XLR balanced analog input connectors (1:
GND, 2: HOT, 3: COLD). Their standard and maximum
input levels depend on the settings of the MIC/LINE
selection switches.
CAUTION
Confirm that phantom power is OFF before connecting a •
line level device to a MIC/LINE IN connector. If you connect
a line level device while phantom power is ON, that device
or this unit could be damaged.
Confirm that phantom power is OFF before connecting or
•
disconnecting a condenser microphone to a MIC/LINE IN
connector. If you connect a microphone while phantom
power is ON, that mic or this unit could be damaged.
Do not connect an unbalanced dynamic microphone to an
•
XLR connector that is supplying phantom power. Doing so
could damage the microphone or this unit.
2 − Names and functions of parts
Rear panel
i Battery compartment
Open the cover to install batteries. See page 17 for
information about the types of batteries that can be used.
o V-Mount bracket attachment holes
You can attach the included V-Mount bracket here. (See
“Attaching a V-Mount type battery” on page 18.)
p Kensington lock mounting hole