Teac HS-P82 - Manual (Page 15)

TASCAM HS-P82
15
PAN/LVL Screen, Playback
Information Screen, Playback
0 Recording media
This shows which of the two CF slots is being used,
as well as the remaining recording time for the current
sampling frequency, bit rate and number of recording
tracks. The background of the media that is currently
being used appears green during playback and red when
recording. If there is no media in the slot, dashes are
shown and the background is grey.
If the card has no project,
NoProject
appears. When
a CF card is inserted during recording into an empy,
unused slot,
UNMOUNT
appears. When recording is
stopped, either the remaining recording time or
NoProj-
ect
appears.
When an unformatted CF card is inserted,
UNFORMAT
appears.
Press this part of the screen to open the
CF SELECT
screen (media selection screen). (See “Formatting a CF
card” on page 23.)
q REC TRACKS button
Press this button to show the record function buttons and
the buttons to edit the take number (Next Take).
Next Take
The take number can be set using one letter from the
alphabet and a number from 1 to 999. Touch the alphabet
area (it becomes yellow) and use the +/- buttons or the
DATA dial to change the value. Press the number area to
highlight it in yellow and turn the DATA dial to change
the value.
In solo mode, the alphabet and the number area cannot
be selected.
When the unit is put in recording standby, the file name
of the take to be recorded is shown above the scene/take
name button on the Home Screen.
In the following cases,
---
appears and the value cannot
be changed.
No project or scene is loaded •
The selected CF card is unavailable •
The current take is 999 •
w PAN/LVL button
Press this button to open a screen with pan pots and
level adjustments for stereo mix recording and the
output signal from
PHONES and LINE OUT .
If you press a
PAN
or
2MixLVL
knob on a channel, the
parameter can be controlled with the DATA dial.
If two channels are linked, the
PAN
knob functions as a
balance adjustment knob.
When in solo mode,
PAN
or
2MixLVL
knob cannot be
selected.
e INFO button
Press this button to show the current settings of the unit
and information about the loaded file.
The
Sys. Info
screen shows the current settings of this
unit. Touch this part of the screen to open the
SYNC T/C
screen.
The
File Info
screen shows information about the
currently loaded file. Touch this part of the screen to
open the
PROJECT
screen.
r Mark List button
Press this button to open the mark list. (See “Mark list
screen” on page 48.)
t Manual Locate button
Press this button to open the screen for locating
manually. (See “Manual locate function” on page 50.)
2 − Names and functions of parts