Verilink PRISM 3111 (34-00242) Product Manual - Manual (Page 49)

Configuration 41
NET Alarms: alarms <CR> <LF>
DTE Alarms: alarms <CR> <LF>
where (alarms) is a string consisting of some or all of the identifiers LOS, OOF,
RAS, AIS, UAS, ERRS or NONE. The following is an example:
Joesunit 17:24:55 08/04/93
NET Alarms: LOS AIS ERRS
DTE Alarms: LOS Port 1
The user programmable Element ID string is transmitted first to allow the COA
function to send a message with a specific meaning to some host (such as a log on
message).
The identifier ERRS represents an alarm that is caused by ES, SES, and/or BPV
errors.
The ASCII alarm report type is set by the following choices:
Dis - (Disable) Alarm reporting is disabled.
Dial - Sends reports through an attached AT command set compatible modem
connected to the SUPV serial port, which must dial out to a remote modem. The
message format is described in the Element ID field.
The unit attempts three times to connect using the primary number. If all three
attempts fail, it will attempt three times to connect using the secondary number (if
it is not blank). If the secondary number fails, the unit waits five minutes and then
attempts to communicate with the primary number again. When a connection is
detected, the unit outputs the notification message (as described in the Element ID
field) and then disconnects.
Dirct - (Direct) Sends reports to a printer or terminal connected directly to the
supervisory port.
Prim Dial String. This field is an ASCII string for the primary call on alarm phone
number used in the Dial mode. The string must NOT include the ATDT command
prefix.
Sec Dial Str. This field is an ASCII string for the secondary call on alarm phone
number used in the Dial mode. The string must NOT include the ATDT command
prefix.
Init Dial Str. The modem initialization string is entered in this field. Refer to the
modem’s documentation for further information. The default setting is ATEQ0V1 .
Dis Conn Str. This field identifies the character string to be output when the
modem session is terminated. The default setting is ATH .
SLIP Parms
SLIP Con. This field controls remote alarm reporting. The trap alarm report type is
set by the following choices:
Dis - (Disable) Alarm reporting is disabled.
✍