Verilink PRISM 3111 (34-00242) Product Manual - Manual (Page 80)

72 C HAPTER 4: T ERMINAL I NTERFACE
Disconnection String
This field identifies the character string to be output when the modem session is
terminated. The default setting is ATH.
SLIP Connection
This field controls remote alarm reporting. The trap alarm report type is set by the
following choices:
Disabled - Alarm reporting is disabled.
Dial - Sends reports through a modem to the SLIP server.
The unit attempts three times to connect. If all three attempts fail, it attempts three
times to connect using the secondary number (if it is not blank). If the secondary
number fails, the unit waits five minutes and then attempts to communicate with
the primary number again. When a connection is detected, the unit outputs the
notification message and then disconnects.
Direct - Sends reports directly to the SLIP server.
Primary Dial String
This field is an ASCII string for the primary call on alarm phone number used in
the Dial mode. This string must not include the ATDT command prefix.
Secondary Dial String
This field is an ASCII string for the secondary call on alarm phone number used in
the Dial mode. This string must not include the ATDT command prefix.
Initialization String
The modem initialization string is entered in this field. Refer to the modem’s
documentation for further information. The default setting is ATEQ0V1.
Disconnection String
This field identifies the character string to be output when the modem session is
terminated. The default setting is ATH.
Compressed SLIP
The choices are Auto, Enable, and Disable. The Auto setting allows the 3111/3112
to negotiate with the far end to enable or disable SLIP compression, depending on
the type of connection.