Wavetronix Command Translator (CMD-DT) - User Guide - Manual (Page 29)

28 CHAPTER 2 • JOB LIST PAGE
˽ Running – Indicates the number of services currently running.
˽ Stopped – Indicates the number of services that are stopped.
˽ Reporting Errors – Indicates the number of services that have reported errors since the
last time they began executing.
Service List
All of the defined services are listed in the Service List, found by clicking the Services tab
(see Figure 2.15). This list is divided into the following columns:
Figure 2.15 – Service List
˽ On/Off – Starts or stops execution on each service. Users with the appropriate access
can click on the check boxes in this column to control service execution; the service is
running if a check mark appears in the box.
˽ Status – Provides users with at-a-glance verification that services are operating prop-
erly. This column will contain one of the colored icons described below:
A green circle indicates that the service is running and no errors were reported.
A red square indicates that the service is running and has reported errors. The
error log on the Service Information page should be consulted for more informa-
tion.
A yellow triangle indicates that the service failed to start.
A grey square indicates that the service is stopped.
˽ Name – Lists the assigned name for the service. Clicking on this column will take you
to the Service Information page, which contains log and error messages and property
information for the selected service.
˽ Description – Explains the service’s purpose, if that information has been entered on
the Add New Service or Service Information page.
˽ Remove – Allows users with the appropriate privilege to permanently remove the ser-
vice from Translator.
Adding and Configuring Services
The Service tab on the Job List page provides a way to add new services to the system as well
as a direct link to view and edit each service’s configuration.