H3C Technologies H3C Intelligent Management Center - Manual (Page 307)

289
• Advanced query offers various query criteria for precise match.
Basic query
1. Access the access device list page.
2. Click Basic Query in the upper-right corner of the page.
If Advanced Query is displayed in the upper-right corner of the page, you are already in basic
query mode.
3. In the Query Access Devices area, enter or select one or more of the following query criteria:
{
Device IP Address Range From/To—Enter an IPv4 address range in which the access device is
located. Enter complete IPv4 addresses.
{
Device Name—Enter a partial or complete name of the access device. UAM supports fuzzy
matching for this field. For example, if you enter lab, all access devices whose names contain
lab are queried.
{
Access Device Type—Select a system-defined or user-defined access device type from the list.
Empty fields are ignored.
4. Click Query to perform the query. The access device list shows all access devices that match the
query criteria.
5. Click Reset to clear the query criteria. The access device list page shows all access devices in
UAM.
Advanced query
1. Access the access device list page.
2. Click Advanced Query in the upper-right corner of the page.
If Basic Query is displayed in the upper-right corner of the page, you are already in advanced
query mode.
3. In the Query Access Devices area, enter or select one or more of the following query criteria:
{
Device IP Address Range From/To—Enter an IPv4 address range in which the access device is
located. Enter complete IPv4 addresses.
{
Device Name—Enter a partial or complete name of the access device. UAM supports fuzzy
matching for this field. For example, if you enter lab, all access devices whose names contain
lab are queried.
{
Access Device Type—Select a system-defined or user-defined access device type from the list.
{
RADIUS Accounting—Select Fully Supported or Partially/Not Supported from the list to specify
support for the RADIUS accounting feature on the access device.
{
Service Group—Select a service group to which the access device belongs from the list.
{
Last Deployed from/to—Enter the time range when UAM last deployed configurations to the
access device, or click the Calendar icon to select the time range. The date and time settings
must be in the format YYYY-MM-DD hh:mm.
{
Last Synchronized from/to—Enter the time range when UAM last synchronized the port
configuration from the access device, or click the Calendar icon to select the time range. The
date and time settings must be in the format YYYY-MM-DD hh:mm.
{
Last Deploy Result—Select the last deploy result from the list. Options are Deployed, Deploy
Failed, Not Deployed, and Deploying.
{
Last Synchronization Result—Select the last synchronization result on the access device from the
list. Options are Failed, Succeeded, Not Synchronized, Synchronizing, and No Sync Needed.