H3C Technologies H3C Intelligent Management Center - Manual (Page 53)

35
{
Add the IP group before adding the portal device.
3. To enter the IP group configuration page, click the User tab, and then select User Access Policy >
Portal Service > IP Group from the navigation tree, as shown in
Figure 25 . For more configuration
information, see " Configuring IP address groups ."
Figure 25 Entering the IP group configuration page
4. Add a portal device and port group.
{
You must add the portal device's information (such as the IP address, portal protocol version,
listening port, and key) to UAM, so packets are properly exchanged between the portal server
and the portal server during authentication.
{
UAM uses port groups to control user accesses. Configure a port group for the target portal
device after configuring the portal device.
{
To enter the portal device configuration page, click the User tab, and then select User Access
Policy > Portal Service > Device from the navigation tree, as shown in
Figure 26 .
{
To enter the port group configuration page, click the Port Group icon for a portal device on
the portal device configuration page. For more configuration information, see "
Configuring
portal devices ."