Grass Valley DD35 Family v.3.1.5 - Manual (Page 113)

2. Panel Operation DD35 Production Switcher
2 – 79 Operating Instructions – Rev. 16 / 10.2001
2.14.1 MACHINE STATUS
The display in top of the Machine Control section will inform you about the current
status of the VTR connection.
no VTR protocol
The driver is not installed. For details refer to your Planning and Installation manual.
VTR not connected
The VTR is not connect. Please check if the device is powered on and the cabling
is OK.
no tape loaded
Tape is ejected.
TC 00:32:16:00
The VTR is connected and ready to be controlled from the DD35. The current LTC
value of the selected device will be shown on the display.
Note: Please check if the VTR is switched to be controlled from
the REMOTE interface.