Grass Valley DD35 Family v.3.1.5 - Manual (Page 396)

3. Menu Operation DD35 Production Switcher
3 – 244 Operating Instructions – Rev. 16 / 10.2001
The vertical cursor softkeys and the vertical cursor digipot are used to navigate
within a list box. The complete cursor control is always relevant.
Modifying the macro. For details refer to section How to store a macro below.
MaKE Bus assignment
Modify:
MaKE button assignment
Modify:
How to store a macro:
D
Make sure that in the Config menu the Running Application is selected to
witch you want to add the macros. If the cursor is not on a Running Applica-
tion the menu item menu
is disabled.
D
Select with the cursor button
↑ ↓
, the digipot or by mouse click a free Key No.
in the Make Memo list field.
D
Push Record button to start recording the macro. Push the desired control
panel buttons and adjust the desired digipots. If a pause is needed between
commands, push the Insert Pause and select the desired time (0.5, 1.0, 2.0,
3.0 or 5.0 in seconds), then proceed with the commands. At the end of the
macro push Record again to stop recording.
Note: If no pause is inserted all commands were executed immediately.
D
If you want to rename the stored commands push Modify and select Rename
in the overlay. Type in the name with the keyboard overlay.
D
To copy a macro to another Key No. select the macro and push Modify. Select
Copy in the overlay. Type in the desired Key No. and confirm with Enter.
Cursor
↑ ↓
Modify