Grass Valley DD35 Family v.3.1.5 - Manual (Page 337)

3. Menu Operation DD35 Production Switcher
3 – 185 Operating Instructions – Rev. 16 / 10.2001
Index card for performing global panel settings and fader adjustment.
Fader Adjustment : Adjustment of the fader end-position values
(fine adjustment of the A/D converters):
Lower end-position: 0% signal, Upper end-position: 100% signal
D
Press Modify, a pup-up menu with dialog messages appears
D
Move all faders to the upper end-position and select the menu entry in the
pup–up menu “Move all faders to the upper position and press OK”
D
Move all faders to the lower end-position and select the entry in the pup–up
menu “Move all faders to the lower position and press OK”
D
The automatic adjustment is finish.
End-position means: move the fader with gentle force as far as it will go.
During the fader adjustment the fader moving have no effect on video signals!
The following settings can be selected and/or adjusted:
PGM/PST Bus Position: PGM above PST / ...
CUT/AUTO Button Position: CUT right / left
Direct Ext DSK Cut/Auto: Off (use 2nd DSK) /
On (2nd funct. –> Trans Dur
ShiftButtons: None / Left / Right / Left and Right
Gang Mode Selection: like transition component select /
like permanent key preview
Enable DSK delegation: enable/disable
DSK1..6 delegation: The 6 DSK delegation buttons of the PP stage
can be used to delegate individually any
internal keyer:
Simulcast Slave Address: Last byte of the defined mainframe IP address
For more personal settings refer to section 3.18 (Personality).
Global