Grass Valley DD35 Family v.3.1.5 User Manual
Page 282
3. Menu Operation
DD35 Production Switcher
3 – 130
Operating Instructions – Rev. 16 / 10.2001
3.10.1.3 How to use Texture Wash
The Texture Wash can be selected in the following way:
D
Select Flat Matte 1 and adjust the desired color
D
Select Flat Matte 2 and adjust the desired color. Matte1 and Matte2 should be
different.
D
Switch on Texture Wash
D
Select the Texture source Key1, Key2, Pattern1, Pattern2 or Mask Bus as
control signal to fade between Matte1 and Matte2. All Texture sources are only
from M/E1.
D
Make sure that Freeze is off
D
Adjust the pattern with the digipot Size or the Key1/2 and Mask Bus with the
Clip and Gain digipot.
D
If desired, the adjusted Key Bus or wipe signal can be stored in the Texture
Store with Freeze
D
The color of Matte1 and Matte2 can be adjusted also with Freeze mode on.
D
The Matte can be switched between Flat, Wash and Texture Wash without
loosing contents of the store.
Note:
Please note that a signal is delayed by one frame when it passes
through the store.