Receiving, Option package contents, Tools required for installation – Yaskawa SI-EN3D User Manual
Page 8: 3receiving
3
Receiving
Please perform the following tasks upon receipt of the option:
• Inspect the option for damage. Contact the shipper immediately if the option appears damaged upon receipt.
• Verify receipt of the correct model by checking the model number printed on the name plate of the option package.
• Contact your supplier if you have received the wrong model or the option does not function properly.
u
Option Package Contents
Description
Option
Ground Wire
Screws (M3)
LED Label
Installation Manual
–
NS
MS
MANUAL
Quantity
1
1
3
1
1
u
Tools Required for Installation
• A Phillips screwdriver (M3 metric or #1, #2 U.S. standard) is required to install the option and remove drive front covers.
Screw sizes vary by drive capacity. Select a screwdriver appropriate for the drive capacity.
• Diagonal cutting pliers. (required for some drive models)
• A small file or medium grit sandpaper. (required for some drive models)
Note:
Tools required to prepare the option cables for wiring are not listed in this manual.
3 Receiving
8
YASKAWA SIEP YAICOM 16A 1000-Series Option Dual-Port EtherNet/IP SI-EN3D Technical Manual