Xerox WorkCentre 7835ii - Manual (Page 318)

Regulatory Information
318 Xerox ® WorkCentre ® 7800/7800i Series Color Multifunction Printer
User Guide
Environmental Benefits of Duplex Printing
Most Xerox products have duplex printing, also known as 2-sided printing, capability. This enables you to
print on both sides of the paper automatically, and therefore helps to reduce the use of valuable
resources by reducing your paper consumption. The Lot 4 Imaging Equipment agreement requires that
on models greater than or equal to 40 ppm color or greater than or equal to 45 ppm monochrome the
duplex function has been auto enabled, during the setup and driver installation. Some Xerox models
below these speed bands may also be enabled with 2-sided printing settings defaulted on at the time of
install. Continuing to use the duplex function will reduce the environmental impact of your work.
However, should you require simplex/1-sided printing, you may change the print settings in the print
driver.
Paper Types
This product can be used to print on both recycled and virgin paper, approved to an environmental
stewardship scheme, which complies with EN12281 or a similar quality standard. Lighter weight paper
(60 g/m²), which contains less raw material and thus save resources per print, may be used in certain
applications. We encourage you to check if this is suitable for your printing needs.
ENERGY STAR
The ENERGY STAR program is a voluntary scheme to promote the development and purchase of energy
efficient models, which help to reduce environmental impact. Details on the ENERGY STAR program and
models qualified to ENERGY STAR can be found at the following website:
www.energystar.gov/index.cfm?fuseaction=find_a_product.showProductGroup&pgw_code=IEQ
Power Consumption and Activation Time
The amount of electricity a product consumes depends on the way the device is used. This product is
designed and configured to enable you to reduce your electricity costs. After the last print it switches to
Ready Mode. In this mode it can print again immediately if required. If the product is not used for a
period of time, the device switches to a Power Saver Mode. In these modes, only essential functions
remain active in order to enable reduced product power consumption.
Upon exiting from Power Saver Mode, the first print will take slightly longer than in Ready Mode. This
delay is the result of the system "waking up" from Power Saver mode and is typical of most imaging
products on the market.
If you wish to set a longer Activation Time or would like to completely deactivate the Power Save Mode,
please consider that this device may then only switch to a lower energy level after a longer period of
time or not at all.
To learn more about Xerox participation in sustainability initiatives, please visit our website at:
www.xerox.com/about-xerox/environment/enus.html