Panasonic LinkRay 70" Class Full HD Commercial LED Display - Manual (Page 100)

English
100
Starting / ending Media Player
■
For Single Media Player
Start
1. Insert the USB memory device for Media Player
to the USB terminal on the side of the display.
Note
● Depending on the type of a USB memory device,
it may come in contact with the periphery such
as a back cover, and cannot be attached. Use a
commercially sold extension cable, or use a small
type of a USB memory device connectable to this
unit.
USB memory
USB terminal
2. Run a USB memory contents check.
3. Change INPUT to [USB].
Ending
Change INPUT to other than [USB].
■
For Multi Media Player
Start
1. Connect several units with LAN cables.
(See “Example of setting up LAN connection and IP
address / Subnet mask” in the previous section.)
2. Insert USB memory for Media Player into each
Display.
3. Executes USB memory contents check on each
Display.
4. Change INPUT for Child to [USB].
5. Change INPUT for Parent to [USB].
Ending
Change INPUT for Parent to other than [USB].
Resume Play function
After Media Player ends, the file to be played back next
time varies depending on the setting of [USB media
player settings] - [Resume play].
When set to [On]:
The file played prior to the end of Media Player starts
playing from the beginning.
When set to [Off]:
Play starts from the beginning of the first file of the
scenario.
Note
● The resume play function is retained until the unit is
turned off or the USB memory device is taken out.
Schedule playback function using
“Content Management Software”
This unit supports “Content Management Software” to
create schedule data on a PC required to play back still
pictures and motion pictures.
Functions that can be set with “Content Management
Software” are as follows.
• Content playback (Still pictures/Motion pictures)
• Music playback
• Input switch
• Power control
• Multi display setting
Note
● To use this function, set [USB media player] and
[Schedule play function] to [Enable] in [Setup] - [USB
media player settings].
● About supported devices, refer to “Supported device”.
(see page 95)
● If both the scenario file of the “USB media player” and
the schedule data of this function are present on the
USB memory device, the [Schedule play function]
operation takes priority.
● When using this function, insert the USB memory
device in power-on state or in schedule standby state.
If the USB memory device is inserted in conditions
other than the said states, the schedule playback is
not performed.
● Functions restricted when using the “USB media
player” are also restricted when using the schedule
playback function.