Panasonic LinkRay 70" Class Full HD Commercial LED Display - Manual (Page 32)

English
32
Note
● Displays the signal name as set in [Input label]. (see
page 51)
● Input will not be switched unless [Input lock] is set to
[Off]. (see page 73)
● Image retention (image lag) may occur on the LCD
liquid crystal panel when a still picture is kept on
the panel for an extended period. To prevent such
a problem, using the screensaver and wobbling is
recommended. (see page 50, 55)
RECALL
It is possible to check the setting status of input label,
picture mode, etc.
Press <RECALL>.
Current setting status will be displayed.
1
2
7
8
3
4
5
6
HDMI1
16:9
AV IN
Memory name: MEMORY2
Schedule play mode
Off timer 90 min
Backup mode OK
1 Input label
2 Aspect mode (see page 34)
3 Backup input change (see page 70, 71)
4 Audio input (see page 72)
5 Profile name (see page 46)
6 [Schedule play mode] (see page 101)
7 Off timer remaining time (see page 33)
8 Clock / Mute (see page 33, 76)
● When there is no video signal to the selected input,
[No signal] is displayed for about 30 seconds at the
end.
● When a USB memory is not connected to the USB
terminal at the time of switching to the USB input, [No
external media] is displayed for about 30 seconds.
Even when a USB memory is connected, if it does not
contain any playable file, [No play file] is displayed at
all times.
● When [No signal image settings] - [Display setting] is
set to [On] (see page 54), the message [No signal] /
[No external media] / [No play file] are not displayed.
Instead, the image set in [No signal image settings]
will be displayed.
● To display the clock, set [Date and time] and then set
[Clock display] to [On]. (see page 57, 76)
Volume Adjustment
Press <VOL +> <VOL -> or <+ (Unit)> <- (Unit)> to
adjust volume.
INPUT
MENU
ENTER
Unit
20 Volume (SPEAKERS)
● The current sound volume level is memorised even if
the power is turned off.
● When [Maximum VOL function] is set to [On], the
volume can only be adjusted to the maximum point
you set, and the displayed value turns red when it
reached its maximum. (see page 73)
● When [Initial VOL function] is set to [On], the volume
will be at the set level when the display is turned on.
(see page 72)