Panasonic LinkRay 70" Class Full HD Commercial LED Display - Manual (Page 16)

English
16
Class ll equipment 55-inch model
49-inch model
43-inch model
Back of the unit
Insert the AC cord all the way until fully seated to
the back side of the unit.
AC cord
(supplied)
Insert the plug until the lines inside are not visible.
Note
● When disconnecting the AC cord, be absolutely sure
to disconnect the AC cord plug at the socket outlet
first.
● The supplied AC cord is for this unit exclusive use.
Do not use this for other purposes.
Cable fixing
Note
● 3 clampers (large: 2, small: 1) are supplied with this
unit. Fix the cables using clampers (Fixation type)
appropriate for each cable as shown below.
If you need more clampers, purchase them from your
dealer. (Available from the customer service)
Attaching positions of the clampers
1 2
1 For AC cord: clamper (small)
2 For signal cable: clamper (large) × 2
1. Attach the clamper
Note
● Wipe off dirt, such as dust, water and oil on the
attachment surface, and affix the clamper on the
attachment surface by pushing it firmly.
● Once the clamper is affixed, it cannot be reused. Be
sure to confirm the attaching position before affixing
it.
Attachment
surface
Remove the tape at the back, and affix the clamper on
the flat surface.
2. Bundle the cables
Pass the tip of the band to the hooks. Then pull and
hook it on the knob.
hooks
knob
To loosen:
Remove the band from the knob, and pull out the band
tip.