Panasonic LinkRay 70" Class Full HD Commercial LED Display - Manual (Page 112)

English
112
Copying the display data to the USB
memory
1 Insert the USB memory device to
the USB terminal at the side of the
display.
USB memory
USB terminal
Note
● Depending on the type of a USB memory
device, it may come in contact with the
periphery such as a back cover, and cannot be
attached. Use a commercially sold extension
cable, or use a small type of a USB memory
device connectable to this unit.
● Failure to save in or read from the USB memory
displays an error message.
2 After the [Select copy type] screen is
displayed, go to the step 6.
When the [Select copy type] screen is not
displayed, follow the steps 3 to 5 to display.
3 Display [Setup] menu pressing
<SETUP>.
4 Select [OSD language] with and
press <ENTER> for over 3 seconds.
The following display appears.
Options
Display software information
LAN data cloning
USB data cloning
Software licenses
Shipping
5 Select [USB data cloning] with
and press <ENTER>.
6 Select [ Display → USB Memory ] with
and press <ENTER>.
Select copy type
Display → USB Memory
USB Memory → Display
7
Select [YES] with and press
<ENTER>.
Data copy to the USB memory starts.
The data will be overwritten when any data exists originally.
Are you OK to write the data?
Data to USB Memory
YES NO
The following message is displayed after data copy
has finished.
Data copy finished.
8 After data copy has finished, remove
the USB memory device from the
USB terminal.