Panasonic LinkRay 70" Class Full HD Commercial LED Display - Manual (Page 105)

105
English
Music
Extension Codec
mp3 MPEG-1/2
Audio Layer-3
AAC(LC)
HE-AAC
(Ver.1)
Sample rate:
Maximum 48 kHz
Channel:
Maximum 2 ch
Bit rate:
Maximum 320kbps wma WMA
Note
● Some information for still image/movie files can be
viewed with a computer where relevant files are
accessible.
● About supported devices, refer to “Supported
device”. (see page 95)
● Some files may not be played back even if they are
supported formats described above.
● If the number of pixels of a file exceeds the screen
size, the picture quality will change.
Operation example
- For Windows computer
1. Right-click a file, and click [Properties].
2. Click the [Details] tab.
- For Mac
1. Click a file while holding down the “Control” key,
and click [Get Info].
2. Click [More Info].
● The maximum size of file is 2 GB.
● The maximum number of file/folder is up to 2000.
If the number exceeds, 2000 files/folders are
displayed.
● You cannot play the files which are protected by
Digital Rights Management (DRM).
● If files or folders include characters other than
one-byte alphanumeric characters, they may not be
displayed correctly, or the playback may not be done
properly.
It is recommended to use only one-byte
alphanumeric characters for files and folders.
● Thumbnails of files may not be correctly displayed
even if they are playable.
● If the file name including the file path (folder
information) and extension has 248 one-byte
alphanumeric characters or more, the thumbnail is
not displayed. (see page 106)
● When playing back in series several kinds of content
with different aspect ratios, the image may be
distorted momentarily when switching content.
It is recommended to unify the aspect ratio for
consecutive playback.
■
Inserting the USB memory
Insert the USB memory to the USB terminal on the
side of the display.
USB memory
USB terminal
■
Removing the USB memory
Make sure that the monitor of the USB memory is not
flashing, and then remove.
Note
● When inserting the USB memory, confirm the
direction of the plug not to damage the terminal.
● Please note following points when removing the USB
memory.
• The indicator of the inserted USB memory will
be blinking while the display is reading out the
data. Do not remove the USB memory while it is
blinking.
• When using a USB memory without indicator, you
cannot recognize when the display is reading out
the data. Please remove it from the display after
closing “Memory viewer” or turning off the display.
• Do not insert and remove the USB memory
frequently. Remove the USB memory at least
5 seconds after insertion. And insert at least 5
seconds after removal. The display needs some
time to detect insertion or removal of the USB
memory.
Note
● During accessing to the USB memory, do not turn off
the power or remove the USB memory because the
data in the USB memory might get damaged. During
accessing, the USB memory is blinking.
● The USB memory allows you to insert or remove
regardless of the power status of the display.