Panasonic LinkRay 70" Class Full HD Commercial LED Display - Manual (Page 27)

27
English
Power of up to 5V/1A can be supplied to an external
device when the picture is displayed.
● If the electric current exceeding the power supplying
capability is applied, the output is blocked, and the
following message is displayed.
[USB DC5V OUT overload. Please remove cable or
equipment, then turn the display off/on.]
In this case, remove the equipment and then turn the
power off/on using the remote control, etc.
Note
● If the direct connection to this unit is not possible due
to the size of a stick PC, etc. use a commercially sold
extension cable.
● Depending on the type of a USB memory device,
it may come in contact with the periphery such
as a back cover, and cannot be attached. Use a
commercially sold extension cable, or use a small
type of a USB memory device connectable to this
unit.
● Depending on the USB memory, the access lamp
may remain blinking even when it is not being
accessed. In this case, remove the device after
switching to the input other than [USB] or [MEMORY
VIEWER].
Also, when reading the user image, remove the
device after the menu screen display finishes (see
page 47). When performing the data cloning, remove
the device after the completion screen is displayed.
(see page 110)
■
Caution on handling and storing the USB
memory
● Do not put USB memory or its cap within close
reach of children. Swallowing it may cause
suffocation.
● If the smoke or questionable odour rises, remove
the USB memory from the equipment and contact
the manufacturer.
● Do not put water, chemical or oil to the USB
memory. It may cause short out or fire.
● Do not put foreign objects or put metal objects to
the USB terminal. Static electricity may cause data
loss or data corruption.
● Do not remove the USB memory from the
computer or the display while the USB memory is
reading out or writing the data. It may cause data
loss or data corruption.
● Do not store the USB memory in hot, humid or
dusty place or near magnetized items.