Dell OptiPlex 7010 Small Form Factor Desktop Computer - Manual (Page 102)

4. Place and align the front I/O-bracket with I/O slot on the chassis.
5. Replace the screw (#6-32) that secures the front I/O-bracket to the chassis.
Next steps
1. Install the processor .
2. Install the heat-sink and fan assembly .
3. Install the WLAN card .
4. Install the solid-state drive .
5. Install the memory modules .
6. Install the expansion card .
7. Install the Optional I/O modules .
8. Install the disk-drive cage .
9. Install the 3.5-inch hard drive if applicable.
10. Install the 2.5-inch hard drive if applicable.
11. Install the front bezel .
12. Install the side cover .
13. Follow the procedure in After working inside your computer .
102 Removing and installing Field Replaceable Units (FRUs)