Dell OptiPlex 7010 Small Form Factor Desktop Computer - Manual (Page 90)

2. Follow the procedure in After working inside your computer .
VGA module
Removing the VGA module
Prerequisites
1. Follow the procedure in Before working inside your computer .
2. Remove the side cover .
About this task
The following image indicates the location of the VGA module and provides a visual representation of the removal procedure.
Steps
1. Remove the two (M2x5) cross-type screws that secure the VGA module to the chassis.
2. Disconnect the VGA-module cable from the connector on the system board.
3. Lift the VGA module off the system board.
Installing the VGA module
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the VGA module and provides a visual representation of the installation procedure.
90 Removing and installing Field Replaceable Units (FRUs)